I never see any amber light flashing and no output on the console terminal. Touch the red multimeter lead to the other wires one at a time. Hi Carlitos, Unfortunatly I haven’t encountered your issue in the past. I spent almost 2 whole days trying to read information to get this working and its not working. I also tried on Windows 7. Hooked up the power and ground to the router. Can some one help me out here?

Uploader: Nikolrajas
Date Added: 2 September 2012
File Size: 41.6 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 19013
Price: Free* [*Free Regsitration Required]

If czble have 4 lines to test, have to guess at RX and unused line. And you can use a USB hub if you want also, as long as its powered.

Arkmicro Technologies Inc. ARK3116 Serial

Never used one before. They are very clsoe together on the Cabble, jeje. Going of another thread here I suspect that the wires in the cable are as follows: Display posts from previous: Hi Carlitos, Unfortunatly I haven’t encountered your issue in the past. You don’t have to break open the end piece.

So when you touch the red multimeter to 1 wire, and the black multimeter to one of the Usb-uaet jack ends, you should see 0 Ohm or hear a Beep That means you have the same wire. If I try to update the drivers for such Arkmciro port and select Win7 drivers from Cypress installed folders then it does change the type of the port to USB serial port but still does not work.

Last Drivers  FLATRON W2286L DRIVER

Xable also tried on Windows 7. In my uneducated guess, I believe this means the colors listed above are correct.

Skip to main content.

man uark (4): Arkmicro Technologies ARK based USB serial adapter

If there is no signal, then you may be on the RX line. I tried the USB device viewer but neither it or windows seems to think there is a connection. Check for continuity with a multimeter between the end that you cut off and canle of the wires on the cut off piece. Black is the only wire to give a reading, and when i touch the red wire, and hold it to the positive lead my Win 7 PC actually recognized the cable.

To test the cable, you have to plug it into the USB port of the computer. Usb-uaft have Win 7 x Installed the driver and utility from the Serial Recovery Wiki.

Can some one help me out here? Really need help for my specific problem please. I know its been said you can find the ground by measuring the ohms with a multimeter set to OHM. Mon Cabld 13, That will tell you which each wire is for, and which is tx, rx, and ground.

Last Drivers  CDC 259EN3 DRIVER DOWNLOAD

Ports – ArkMicro – ArkMicro USB to Serial Ports Computer Driver Updates

Then compare the wire colour to the picture linked to in the wiki. You can google how to use a multimeter. I spent almost 2 whole days trying to read information to arkmlcro this working and its not working. How else can you tell which wire runs to which pin if you dont crack open the end? Wrong unfortunately, the multimeter does NOT provide power. Hooked up the red cable to match up to the 3V3 pad on the router for power and twisted the blue and white just to test out the prolific drivers from the wiki.

Cannot see new device, COM port in device manager. Mon Jun 13, 0: Please try looking at these posts http: Community Projects View Projects.

Zedboard forums is currently read-only while it under goes maintenance.